![]() ![]() I would be great if someone one could explain the difference between using pin 10 vs using any of the other PWM pins for SS.Īny other advice concerning my project or SPI is greatly appreciated too. I tired using the PWM pins 3, 5 and 6 as the SS pin and the drone worked perfectly. ![]() I was also wondering what is so special about pin 10(SS pin) on the UNO. Again, I am not sure if this is correct, please correct me if wrong. But the SS must be different for each device. Not too sure if this is correct, I read that the MISO, MOSI and SCK will remain the same for both devices. I need to understand how to use SPI with two slave devices. Now my problem is, the Arduino USB host shield for the controller uses SPI as well. I will be following this build: Using a USB host shield and a Bluetooth dongle to get data from a PS3 controller – Success! | Barrett's Projects. This board is a perfect entry point to learn MicroPython, dive. USB-C connector, 16 MB (128 Mbit) of Flash, support for MicroPython & Arduino IoT Cloud enabled, it is a very versatile development board. It is extremely difficult to operate, so I am looking into using a DualShock3 controller with the Arduino. The Arduino Nano ESP32 is the first ever Arduino board based on a ESP32 microcontroller from Espressif, the NORA-W106 module from u-blox. Everything is working, my flight controls are operated using the 4 potentiometers. I am using the Arduino uno and SPI with a wireless transceiver. I am building my own set of flight controls for an existing drone, pretty much much most of the project is done. I am new to this forum and to Arduino, currently I am working on a school project and I was looking for an explanation concerning SPI.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |